This is a notebook Acer Aspire 5,610 my water damaged screen I will. fix.First all remove the battery from notebook.
Warning: LCD screens are easily damaged if you open. up. If you do something wrong the screen becomes completely unusable and you must buy a new monitor. It's very expensive. Think twice before deciding to open the screen. The risk of your own.
Inverter board version is attached to a second screen. This screws. Remove the screws, disconnect cable and remove the screen Inverter board.
With sticky tape and peel off and I think together. You will need to put back in position between. reassembly screen.
Remove the two screws, both of the screen.
Lifting screw rubber seal and remove all screws.
Target href "=". _blank = "http://www.sunvalleyus.com/LCDPanel/"> http://www.sunvalleyus.com/LCDPanel/.
Carefully separated from the screen bezel. LCD cover and remove bezel.
Remove the two screws. From both the front and two screws.
Remove the LCD screen with cover and places. On the notebook base. Remove the cable and video cable Inverter board.
At the screen upside down on a flat surface. Unglue a film covering. Circuit and remove the two screws from the board. (Top players). I do not really have that, if removed. screws on the bottom so that I issued in the case. No hand contact circuit board.
After both screws out, you should be able to lift circuit. Beware it is attached to the LCD.
Start. unsnapping metal frame of the screen. Is more. all the latches of the screen. You can unlock them with a nail or screwdriver. small flathead.
After the latches are open, you should be able to split the screen into three parts:. Metal Frame LCD and background (not sure about correct technical name).
If you have lint or dust. Within the screen, you may find it between. LCD and background. Not touch LCD or after your hands. I can remove dust and lint with a soft cloth and more. LCD and just touch the surface.
After the split screen found behind a light layer types. (Three transparent sheets) and in some cases, some of them have been damaged by water. Water dried out and left stains between these optical layer.
In the case of removing dust and lint is not enough and I will continue.
Carefully separate the LCD with attached circuit board from the background.
To remove damaged optical layer are required to remove the metal lock. Side of the screen. Would like to make a small clip on the floor.
After all I can see a clip from the floor. The first time I try to wash. Dry water marks with a soft cloth but do not help. Stain is still visible and do not want to be.
Fortunately, I have a screen similar. Place around it is cracked LCD. I decided to borrow light from the floor cracked screen and transfer to my screen. I'm not sure, but as I get to work. Prior to that I do not really care if I break the screen. It is a test.
So I am. disassembled the screen cracked and transfer a white background. And transparency in the top of my screen.
To avoide damage water can be used if sleeve. Target href "=" _blank =. "http://www.sunvalleyus.com/Cooling-Laptop-Case/"> http://www.sunvalleyus.com/Cooling-Laptop-Case/.
After I combined. My screen to remove dust and lint with a very soft cloth. Connect breathlessly to display my new notebook. Open top and ...
It is a miracle. Job!
About the Author:
Article Source: ArticlesBase.com - How to do when LCD screen meet water damage
iBook G3 Fix : Inverter Board
US $53.09
No comments yet.
Leave a comment